Complete seat replacement for 2011-2015 Single BOB Revolution Flex, Revolution SE, and Revolution CE in Black.
- Canopy and Lowboy Cargo Basket sold separately.
- Check your Serial Number or Contact Us with any questions. Also, see our blog on fabric parts.
Compatible Strollers based on Serial Number (Model, Serial Number range, Manufacture Date range listed below):
- Revolution FLEX: EC000001 and higher, EE000001 and higher (2014 - Sept. 2015)
- Revolution SE: BB000001 and higher (Late 2010/2011 - Sept. 2015)
- Revolution CE: AP000001 and higher (Late 2010/2011 - Sept. 2015)
NOTE! Early model 2011 BOB Strollers may have manufacture dates in late 2010, but are designated 2011 based on the Serial Number.
BOB (Britax) does not have a seat replacement instructional video for the 2011-2015 model year strollers. However, they do have one for 2016 and newer which can be viewed here. There are some subtle changes between these model years, but you may find this video very helpful. They do remove both sides of the fold release cable and shock release pins, but only one side is necessary with 2011-2015 models...read on.
Tips for removal of old seat and installation of new seat: Take some digital images of the key attachment points of the hardware so you will know how and where to put everything back upon installation of the new seat. Remove all of the associated hardware and place in a jar for safe keeping (in case new hardware is not included). Dismantle only one side of the fold release cable from the back of the shock release pin prior to removing the old seat (*see this video, ~1 minute in). There is no need to remove both sides of the cable. You just need to pull it out from the nylon loops under the old seat. You can leave it dangling from the side on which it is still secured until you feed it through the nylon loops under the new seat.
*Video link is for Swing Arm replacement, but the section relevant to the fold release cable starts about 1 minute into the video.
3 Reviews Hide Reviews Show Reviews
Fits like original. Easy to install. Very happy I purchased it
Was really glad to be able to replace the seat after we bought a used Stroller with worn out straps. The seat installed easily enough with the instructions provided but the seat tore at both of the grommets on the 3rd screws up from the bottom after only 2 months of moderate use. Response: Please contact BOB directly if you feel this is a warranty concern so we can take care of this. http://www.bobgear.com/support/warranty-return-policy
The seat is pretty solidly made, but there are a few caveats here... one: it's a bit nuts to have to replace the ENTIRE seat just because the seatbelt wore out. Methinks the design could be much improved so that we didn't need to replace the entire seat because 1% of it failed. Secondly, the instructions were poor. To wit: there are different lengths of screws that must be used in different places. For example, the screw that holds the front-wheel cover on MUST be short, otherwise it will jam and prevent the front wheel from turning. It's a not-so-minor detail totally without mention in the instructions.